Buying guide · Measuring
How to Measure for Bifold & Patio Doors
Getting your measurements right is the most important part of ordering made-to-measure doors. This guide walks you through measuring an opening for aluminium bifold doors, sliding patio doors and French doors, step by step.
You will need a steel tape measure, a spirit level and a pencil and paper. If you are replacing existing doors, measure from the inside and the outside, and take the smallest figures.
1. Measure the width
Measure the width of the opening brick to brick (or between the plastered reveals if there is no frame) in three places: at the top, in the middle and at the bottom. Write all three down and use the smallest measurement.
2. Measure the height
Measure the height from the finished floor level (or the top of the existing cill) to the underside of the lintel in three places: on the left, in the middle and on the right. Again, use the smallest measurement.
3. Check the opening is square
Measure both diagonals, corner to corner. If they are within a few millimetres of each other the opening is square. A big difference means the opening is out of square, and you should allow more fitting tolerance or speak to us before ordering.
4. Allow for fitting tolerance
Doors need a small gap all round so they can be fitted level and plumb and then sealed. As a rule of thumb, take around 10mm off the width and 10mm off the height of your smallest measurements to get your frame size. Openings that are uneven or out of square may need more.
All sizes in our shop are overall frame sizes. If you are unsure how a cill or threshold affects your overall height, contact us before ordering and we will check it with you.
5. Choose the number of panels (bifolds)
Bifold doors work best when each panel is roughly between 600mm and 1200mm wide. As a guide:
- 3 panels – openings from around 2000mm to 3600mm wide
- 4 panels – openings from around 3000mm to 4400mm wide
- 5 panels – openings from around 3600mm to 5000mm wide
More panels mean narrower doors that stack more neatly when open, and more frames in the view when closed. Fewer panels mean bigger panes of glass. Our bifold vs sliding doors guide can help if you are still deciding which type of door to choose.
6. Think about the floor and threshold
Decide whether you want a cill with a standard threshold or a low threshold for a near-level finish between inside and out. Each has pros and cons – see our threshold guide before you order.
Before you order
- Check the lintel above the opening is sound and suitable for the new doors.
- Make sure your builder or installer is happy with the sizes – they will be fitting them.
- Remember all our products are made to measure, so they cannot be returned if the size is wrong.
Not sure? Send us your measurements and a photo of the opening through our contact page or call 01924 929600 and we will check them before you order.
Measured up?
Find your size in the shop with prices shown up front, or design an exact bespoke size online.